自動攪拌一體機中油霧器的作用是使?jié)櫥挽F化后注入空氣流中,并隨空氣進入需要潤滑的部位,所以油霧器中潤滑油必須要保持在正常位置,不能過多也不能偏少。
The function of the oil atomizer in the automatic mixing machine is to make the lubricating oil be injected into the air flow after atomization, and enter the parts needing lubrication along with the air. Therefore, the lubricating oil in the oil mist atomizer must be kept at the normal position, neither too much nor too little.
1.運行前檢查事項
1. Inspection items before operation
自動攪拌一體機氣路系統運行前要檢查潤滑油的油位,保持油面在油尺上下線之間,油面接近下線時,要及時增加,油霧器滴油正常、油杯底部沉積無水分、油杯口密封圈完好。
Before the operation of the air circuit system of the automatic mixer, the oil level should be checked to keep the oil level between the upper and lower lines of the dipstick. When the oil level is close to the line, it should be increased in time. The oil mist device drips normally, there is no water deposited at the bottom of the oil cup, and the seal ring of the oil cup mouth is in good condition.
2.添加潤滑油注意事項
2. Precautions for adding lubricating oil
①添油的時候要在沒有壓力的狀態下進行,操作之前要整理混凝土攪拌機周圍的塵埃等雜物,避免進入油霧器。
① When adding oil, it should be carried out under the condition of no pressure. Before operation, the dust and other sundries around the concrete mixer should be sorted out to avoid entering the oil mist generator.
②油霧器中潤滑油選用普通柴油機機油,可以用粘度為2.5-7度的潤滑油或許工業用40#機油。貯油杯內機油要及時更換,貯油杯的容量按100ml計算,使用100小時為宜。
② The lubricating oil in the oil mist eliminator is ordinary diesel engine oil. The lubricating oil with viscosity of 2.5-7 degrees may be used for industrial use. The oil in the oil storage cup should be replaced in time. The capacity of the oil storage cup is calculated as 100ml, and it is suitable to use it for 100 hours.
3.維護保養
3. Maintenance
定期清洗空氣混凝土攪拌機濾清器濾芯,因為濾芯過臟導致進入壓縮機氣缸內的空氣含塵過多,加速氣缸和活塞環的磨損,并且易形成積碳影響氣閥的密封性;嚴重時還會引起拉缸、竄氣,造成潤滑油的污染,影響潤滑效果;竄氣的時候,還會產生上油現象,汽缸壁和活塞環的間隙過大,被污染的潤滑油會竄入壓縮室內并形成油霧,從而污染壓縮空氣。
Clean the filter element of the air concrete mixer regularly. Because the filter element is too dirty, the air entering the compressor cylinder contains too much dust, which accelerates the wear of the cylinder and piston ring, and is easy to form carbon deposit, which affects the sealing performance of the air valve; in serious cases, it will cause cylinder pulling and air channeling, causing the pollution of lubricating oil and affecting the lubrication effect; when the air channeling occurs, there will be oil filling phenomenon on the cylinder If the gap between the wall and the piston ring is too large, the contaminated lubricating oil will enter the compression chamber and form oil mist, which will pollute the compressed air.
自動攪拌一體機有限公司——山汽提醒您想要延長自動攪拌一體機的使用壽命,一定要嚴格按照正確方法操作!
Automatic mixing machine Co., Ltd. - Shanqi reminds you that if you want to extend the service life of the automatic mixing machine, you must operate in strict accordance with the correct method!