攪拌一體機液壓泵使用要注意什么問題?
What problems should be paid attention to when using the hydraulic pump of the mixer?
攪拌一體機的正常運行是通過液壓系統執行的。液壓泵和馬達也是液壓系統特別是液壓泵的重要組件。在下一個小系列中,我們將介紹使用液壓泵時的一些預防措施。
The normal operation of the mixer is carried out by hydraulic system. Hydraulic pump and motor are also important components of hydraulic system, especially hydraulic pump. In the next small series, we will introduce some precautions when using hydraulic pumps.
使用前,請確保液壓泵就位,并擰緊螺釘,并在必要時安裝聯軸器。接下來,檢查泵體是否充滿了符合標簽要求的液壓油。仔細檢查泵的轉向是否與進口和出口相匹配,以及液壓系統中的閥是否已調節壓力值。
Before use, make sure that the hydraulic pump is in place, tighten the screws, and install the coupling if necessary. Next, check that the pump body is filled with hydraulic oil that meets the label requirements. Carefully check that the steering of the pump matches the inlet and outlet, and that the relief valve in the hydraulic system is adjusted to the pressure value.
使用攪拌一體機的液壓泵時,請勿以大速度啟動。在連續進行空載操作之前,必須在系統卸載時將原動機開關打開幾次。目標是從管道中盡可能多的空氣。運行1-2分鐘后,沒有出現異?,F(xiàn)象,負載逐漸增加。確保在加載過程中沒有異常的振動,噪音或泄漏。否則,請停止檢查并立即排除故障。
Do not use hydraulic mixer at high speed. Before continuous no-load operation, the prime mover switch must be turned on several times when the system is unloaded. The goal is to remove as much air as possible from the pipe. After running for 2 minutes, the load did not increase gradually. Make sure there are no abnormal vibration, noise or leakage during loading. Otherwise, please stop the inspection and correct the fault immediately.
長時間使用后,請注意更換液壓油并確保泵正在運行。
After using for a long time, please pay attention to change the hydraulic oil and make sure the pump is running.
攪拌一體機液壓泵使用要注意的事情了解就是這些,你學會了嗎?
Mixing machine hydraulic pump use should pay attention to things to understand these are, you learned?