今天我們小編就來給您介紹自動上料攪拌車的保養注意事項,希望通過我們的介紹讓您對自動上料攪拌車的保養注意事項等問題有更深入的了解
Today, our editor will introduce you to the maintenance precautions of automatic feeding mixer truck. We hope that through our introduction, you can have a deeper understanding of the maintenance precautions of automatic feeding mixer truck and other issues
1、在施工現場卸料完畢后,應立即用攪拌車隨帶的軟管沖洗進料斗、出料斗、卸料熘槽等處,清理粘附在車身各處的污泥及混凝土。在返回?cái)嚢枵镜耐局?,?yīng)向攪拌筒內注150---200L水以清洗筒壁及葉片粘結的混凝土殘?jiān)?/div>
1. After unloading at the construction site, immediately flush the inlet hopper, outlet hopper and unloading chute with the hose attached to the mixer truck, and clean the sludge and concrete adhered to the vehicle body. On the way back to the mixing plant, 150-200l water shall be injected into the mixing drum to clean the concrete residue bonded to the drum wall and blades.
2、每天工作結束后,司機應負責向攪拌筒內注入清水并高速(14—18轉/分)旋轉5—10分鐘,然后將水排去,以保證筒內清潔。用高壓水清洗攪拌筒各個部分時,應注意避開儀表及操縱桿等部位。壓力水噴嘴與車身油漆表面間的距離不得小于40厘米。
2. After the mixing drum is rotated at a high speed for 18 minutes, the driver shall be responsible for the cleaning of the mixing drum, and then the water shall be discharged into the mixing drum at a high speed for 5 minutes every day. When cleaning all parts of the mixing drum with high-pressure water, pay attention to avoid instruments, control rods and other parts. The distance between the pressure water nozzle and the paint surface of the vehicle body shall not be less than 40cm.
3、清理攪拌筒內外積污及殘存的混凝土渣塊時,以及在機修人員進入筒內進行檢修和焊補作業時,需先關閉汽車發動機,使攪拌筒完全停止轉動。在機修人員進入筒內工作期間,需要保證拌筒內通風良好,空氣新鮮,無可然氣體及有害灰塵,氧氣供應充足。在筒內使用電動工具操作時,操作人員需要有良好的絕緣保護。
3. When cleaning the dirt and residual concrete slag inside and outside the mixing drum, and when the mechanical maintenance personnel enter the drum for maintenance and welding repair, it is necessary to turn off the automobile engine first to stop the mixing drum completely. During the period when the mechanical maintenance personnel enter the drum for work, it is necessary to ensure that the mixing drum is well ventilated, the air is fresh, there is no combustible gas and harmful dust, and the oxygen supply is sufficient. When using electric tools in the cylinder, the operator needs to have good insulation protection.
4、工作時,不得將手伸入旋轉的攪拌筒內,嚴禁將手伸入主卸料熘槽和加長卸料熘槽的連接部位自動,自動上交攪拌車在工作時應注意什么以免發生事故。
4. When working, do not put your hand into the rotating mixing drum. It is strictly prohibited to put your hand into the connecting part of the main unloading and frying tank and the extended unloading and frying tank. What should be paid attention to when working to avoid accidents.
由于混凝土?xí)诙虝r(shí)間內凝固成硬塊,且對鋼材和油漆有一定的腐蝕性,所以每次使用混凝土貯罐后,洗凈粘附在混凝土貯罐及進出料口上的混凝土是每日維護一定要認真進行的工作。其中包括:
Since the concrete will solidify into hard blocks in a short time and have certain corrosivity to steel and paint, cleaning the concrete adhered to the concrete storage tank and the inlet and outlet after each use of the concrete storage tank is a daily maintenance work that must be carried out carefully. These include:
1.每次裝料前用水沖洗進料口,使進料口在裝料時保持濕潤;
1. Wash the inlet with water before loading each time to keep the inlet moist during loading;
2.在裝料的同時向隨車自帶的清洗用水水箱中注滿水;
2. Fill the cleaning water tank with water while loading;
3.裝料后沖洗進料口,洗凈進料口附近殘留的混凝土;
3. After loading, wash the inlet and clean the residual concrete near the inlet;
4.到工地卸料后,沖洗出料槽,然后向混凝土貯罐內加清洗用水30—40 L;在車輛回程時保持混凝土貯罐正向慢速轉動;
4. After unloading at the construction site, wash the discharge tank, and then add 30-40 l of cleaning water to the concrete storage tank; Keep the concrete storage tank in the forward direction when the vehicle rotates slowly;
5.下次裝料前切記放掉混凝土貯罐內的污水;
5. Remember to drain the sewage in the concrete storage tank before the next loading;
6.每天收工時徹混凝土貯罐及進出料口周圍,保證不粘有水泥及混凝土結塊。
6. At the end of each day, penetrate around the concrete storage tank and the inlet and outlet to ensure that there is no cement and concrete caking.
The above is a detailed introduction to the automatic mixer, which I hope will be helpful to you If you have any questions, please contact us We will provide you with professional service http://klalyy.cn/