隨著市場的多樣化,市場上現有的自動上料混合設備的質量不均衡。對于許多商家來說,購買設備也存在一定的困難。因此,我將教你一些區分自動攪拌一體機質量的方法。
With the diversification of the market, the quality of the existing automatic feeding mixing equipment is not balanced. For many businesses, there are some difficulties in purchasing equipment. Therefore, I will teach you some ways to distinguish the quality of automatic mixer.
1.自動攪拌一體機材料對其質量的影響不容忽視。良好的材料在使用時具有一定的耐腐蝕性,耐壓性和小的阻力。
1. The influence of materials on the quality of automatic mixer can not be ignored. Good material in use has a certain degree of corrosion resistance, pressure resistance and small resistance.
2.除材料外,還一定遵守自動上料攪拌車過濾器的端蓋與金屬之間的接觸。
2. In addition to the materials, the contact between the end cover of the automatic feeding mixer filter and the metal must be observed.
3.在購買過程中,有必要了解攪拌一體機的過濾元件是否可以回收,是否可以用水沖洗等,其使用壽命和使用壽命需要有一定的了解。
3. In the purchase process, it is necessary to know whether the filter elements of the mixer can be recycled, whether it can be washed with water, etc., and its service life and service life need to have a certain understanding.
我相信在了解了這些知識之后,我們還可以看到過濾器和濾芯對自動送料混合器質量的影響是重要的。因此,在采購過程中,您必 須充分了解其質量。它可以保證設備在使用過程中的正常性能和效果。
I believe that after understanding this knowledge, we can also see that the influence of filter and filter element on the quality of automatic feeding mixer is important. Therefore, in the purchasing process, you must fully understand its quality. It can ensure the normal performance and effect of the equipment in use.
自動攪拌一體機的安 全程序
Safety program of automatic mixer
1.在駕駛之前,您一定仔細檢查車輛的狀況,以確保車輛能夠安 全駕駛。
1. Before driving, you must carefully check the condition of the vehicle to ensure that the vehicle can drive safely.
2.當攪拌一體機停放在露天時,攪拌桶應在裝料前翻轉,并應排出積聚的水和碎屑,以確?;炷恋馁|(zhì)量。
2. When the mixer is parked in the open air, the mixing bucket shall be turned over before loading, and the accumulated water and debris shall be discharged to ensure the quality of concrete.
3.運輸混凝土時,確保傾斜槽牢固放置,防止因松動而擺動,行人在行駛中受傷或影響其他車輛的正常運行,同時注意避免混凝土溢出和污染地面。
3. When transporting concrete, ensure that the inclined slot is firmly placed to prevent swinging due to looseness, pedestrian injury during driving or affecting the normal operation of other vehicles, and pay attention to avoid concrete overflow and ground pollution.
4.攪拌機不應運輸混凝土超過攪拌站規定的時間。在運輸混凝土的途中,攪拌筒不應長時間停止,以防止混凝土的分離。駕駛員應始終注意具體情況,并在發現異常時通知主控室,并申請。
4. The mixer shall not transport the concrete beyond the time specified by the mixing plant. During the transportation of concrete, the mixing drum should not be stopped for a long time to prevent the separation of concrete. The driver should always pay attention to the specific situation and inform the main control room when finding any abnormality and apply for treatment.
5.當混凝土安裝在車內時,現場的停滯時間不得超過1小時。如果超時,應要求現場負責人及時處理。
5. When the concrete is installed in the vehicle, the dead time on site shall not exceed 1 hour. In case of overtime, the person in charge of the site shall be required to deal with it in time.
6.當自動上料攪拌車通過非泵運輸時,應從混凝土排放到油箱。溫度高時,不得超過2小時。如果超過2小時,一定將其排出。在陰雨天氣溫度較低時,不應超過2.5小時。
6. When the automatic feeding mixer is transported by non pump, the concrete shall be discharged to the oil tank. When the temperature is high, it shall not exceed 2 hours. If more than 2 hours, it must be discharged. When the temperature is low in rainy weather, it should not exceed 2.5 hours.
7.在排出混凝土之前,攪拌筒應以10-12rpm的速度旋轉1分鐘,然后排出。
7. Before discharging the concrete, the mixing drum shall be rotated at a speed of 10-12rpm for 1 minute, and then discharged.
8.當自動攪拌一體機完成后,應將水從車輛的軟管中排出,并應將進料口,卸料斗和卸料槽沖洗并排干,以去除粘附在車身上的污垢和殘留混凝土。保持車輛衛生。
8. After the completion of the automatic mixer, the water shall be discharged from the hose of the vehicle, and the inlet, discharge hopper and discharge groove shall be washed and drained to remove the dirt and residual concrete adhered to the vehicle body. Keep the vehicle clean.