1.全自動一體式攪拌車啟動卡車發動機后,以低速運行攪拌機約10分鐘,以使液壓油溫度高于20°C。
1. After starting the truck engine, run the mixer at low speed for about 10 minutes to make the hydraulic oil temperature higher than 20 ° C.
2.在此之前,將攪拌桶上下顛倒。
2. Before that, turn the mixing drum upside down.
3.全自動一體式攪拌車卡車運輸?shù)幕炷撂涠缺仨毶贋?厘米。從混凝土進入儲罐到卸貨的高溫不應超過2小時,而在雨天的低溫不應超過2.5小時。
3. The slump of concrete transported by fully automatic integrated mixer truck must be at least 8 cm. The high temperature from the concrete entering the storage tank to unloading shall not exceed 2 hours, and the low temperature on rainy days shall not exceed 2.5 hours.
4.全自動一體式攪拌車在將混凝土卸到卡車上之前,攪拌箱應以10-12rpm的速度旋轉1分鐘。
4. Before unloading the concrete onto the truck, the mixing tank should rotate at the speed of 10-12rpm for 1 minute.
5.全自動一體式攪拌車.混凝土自動攪拌機卸載卡車后,使用卡車軟管清潔進水口,排水漏斗,卸載箱等零件,以車廂各個部位的污垢和殘留的混凝土。倒入150-200升純凈水桶中。在返回過程中,緩慢旋轉混合槽以清潔內壁,以防止殘留的爐渣粘附到混合槽壁和混合葉片上,排干水,然后重新填充。
5. Fully automatic integrated mixer. After the automatic concrete mixer unloads the truck, use the truck hose to clean the water inlet, drainage funnel, unloading box and other parts, so as to remove the dirt and residual concrete in all parts of the carriage. Pour into 150-200 liter pure water bucket. During the return process, slowly rotate the mixing tank to clean the inner wall to prevent residual slag from adhering to the mixing tank wall and mixing blades, drain the water, and then refill.
6.從全自動一體式攪拌車運輸混凝土?xí)r,發動機轉速應在1000-1400rpm的范圍內,以確保大的發動機扭矩。在運輸混凝土的過程中,為了駕駛,車輛的速度不得超過40km/h。
6. When transporting concrete from the fully automatic integrated mixer, the engine speed shall be in the range of 1000-1400rpm to ensure large engine torque. During the transportation of concrete, in order to drive safely, the speed of the vehicle shall not exceed 40km / h.
7.使用全自動一體式攪拌車完成物料裝載后,清潔攪拌器的內部和主體,以使攪拌器中沒有殘留的混凝土。
7. After the material loading is completed by using the fully automatic integrated mixer, clean the interior and main body of the mixer so that there is no residual concrete in the mixer.